Revolutionary product>>The savior of hard material tapping>>Replaceable tungsten steel milling cutter

Suitable for stainless steel, pre-hardened steel or materials with hardness up to HRC62
At present, discharge tapping is mostly used when tapping screw holes on hard materials, especially heat-treated plates.

The processing time of 1 hole is about 30~~40 minutes.
It is time-consuming and costly. The quality of the processed screw holes is very poor. The opening is too loose and the bottom of the hole is too tight. Although using traditional milling cutters is fast, the cost per piece is high and the lifespan is short.
converting to NC code is also complicated and not easy to get started. After years of research and development, our company not only has a low unit price, but also has chamfering function, longer service life, and only needs to process 1 hole.
1~~3 minutes, and each knife comes with the NC code exclusively developed by our company, which already contains the rotation speed and feed amount. Not only is the program short, but the compatibility is also high, no matter what
It can handle both single hole processing and multi-hole processing easily.

Through innovative design, ordinary steel is used as the main body, and the blade is made of disposable special tungsten steel, which greatly reduces the price. The end of the blade uses three stages of chamfering.
Different from traditional milling cutters that cannot perform chipping processing, even if they are processed with old machines, they can still be processed with ease. Using traditional cutting and disinfecting fluids can achieve 10 times the service life.
Through the physical processing test, the service life of each tooth cutter can reach 50-100 holes (tested with material SKD11, hardness HRC60, M10 milling 10 teeth)
If the processed object is white iron (stainless steel), the processing life can reach more than 2,000 holes.