展覽主題
數位轉型
綠色轉型
彰化振榮油機股份有限公司
產品描述 :
1. 特點是「油量固定」，亦即每個潤滑點可獲得同樣的潤滑油量。
2. T型分配器有多種吐出量可供選擇: 0.1cc、0.2cc、0.3cc、0.4cc、0.5cc，訂購時請先告知孔數與每孔預定之吐出量。
3. 每個出油孔均有檢知棒，具檢知功能，可目視動作是否異常，如再選搭微動開關，可於動作或間歇時產生訊號，更容易觀察動作狀態。
4. T型分配器每次動作時均將潤滑油儲存於分配器管內，而每次間歇時注油。
5. T型分配器0.5cc可加裝微動開關裝置，客戶可自行設定為NO(常開)或NC(常閉)，亦可兩者皆設定。設定為NO常開時，會於每次動作儲油時產生訊號，設定為NC常閉，則會每次間歇注油時產生訊號。
6. 須搭配脫壓式機油注油機使用，最低啟動壓力則為8kgf/c㎡，最高工作壓力為30kgf/c㎡。
7. 使用油品之黏度範圍:機油32-90 cSt@40℃。
HYDROKOMP GmbH
產品描述 :
Coupling elements of HYDROKOMP are made of stainless materials. This enables the elements to be used for all fluids and gases that are not aggressive. Special designs eg. for water steam or other media are available on request. HYDROKOMP offers coupling elements for two different operating modes depressurized coupling or pressurized coupling. The elements for depressurized coupling can be coupled pressurized up to 25 bar, if the specified volume flow is not be exceeded. When using higher operating pressure there ockures a risk of demaging the soft seal in the check valve as the result of high flow velocities of the fluid. This means for coupling of air up to 10 bar there should be always used the coupling elements for depressurized coupling. This also applies when the coupling process is initiated pressurized. The elements which can be coupled pressurized may be coupled up to the maximum specified operating pressure on one side and / or on both sides.
HYDROKOMP GmbH
產品描述 :
Swing clamp cylinders release the clamping point on the workpiece. With this, it is easy to change the workpiece. This hydraulic swing clamp cylinder operates as single-acting or double-acting traction cylinder, whereas part of the stroke is used to rotate the piston. The model with 0° swing angle operates only vertical as traction cylinder.
To guarantee a long lifetime the cylinders have an integrated metal wiper as standard. For oil supply, the cylinders are equipped with threaded port and manifold port with O-ring for drilled channels. You can select between right or left turning models with various standardized swing angles. The integrated overload protection protects the swing mechanism from damage due blockage of the rotation or improper assembly of the clamping arm.
For any risk of exceeding the permitted volume flow a throttle check valve must be interposed into the oil supply line. Counter-hold the clamping arm when tightening or loosening the counter nut in order to prevent torque transfer to the piston rod and to avoid damage to the ball guide. Variations with 0°, 30°, 45°, 60° and 90° swing angles are available. The permitted operating pressure is depending from the clamping arm length.
